Posts for: July, 2016

By Ocean Drive Dentistry
July 16, 2016
Category: Dental Procedures
Tags: x-rays  
BitewingX-RaysanImportantToolinEarlyToothDecayDetection

It's difficult to measure how x-ray imaging has transformed dentistry since its use became prominent a half century ago. As equipment and methods standardized, the technology revolutionized the way we diagnose tooth decay and other mouth-related issues.

One of the more useful of these methods is called the bitewing x-ray. The term comes from the shape of the device a patient holds between their teeth with the film attached on the side toward their tongue. We direct the x-ray beam to the outside of the patient's cheek, where it passes through the teeth to expose on the film. Its particular design provides clearer images since the patient's bite helps keep the film still and distortion-free, making it easier to view signs of early tooth decay.

Bitewing x-rays usually consist of four films, two on either side of the mouth, necessary to capture all of the teeth (children with smaller jaws, however, often only require one film per side). How frequently they're conducted depends on a number of factors, including the patient's age: children or young adolescents are usually filmed more frequently than adults, usually every six to twelve months. Frequency also depends on a patient's particular decay risk — the higher the risk the more frequent the x-ray.

Regardless of how often they're performed, a similar application principle applies with bitewing x-rays as with any other radiological method: As Low As Reasonably Achievable (ALARA). With the ALARA principle in other words, we're looking for that sweet spot where we're able to detect the earliest stages of dental disease with the least amount of radiation exposure.

Bitewings fit this principle well: a patient receives only a fraction of the radiation exposure from a four-film bitewing as they do from a daily dose of environmental radiation. Factor in new digital technology that reduces exposure rates and bitewings pose virtually no health risk to patients, especially if conducted in a prudent manner.

The benefits are well worth it. Thanks to bitewing x-rays we may be able to diagnose decay early and stop it before it causes you or your family member extensive tooth damage.

If you would like more information on the importance of x-rays in dentistry, please contact us or schedule an appointment for a consultation.


JimmyFallonCanrsquotCatchaBreak-ExceptinHisTooth

Want to know the exact wrong way to pry open a stubborn lid? Just ask Jimmy Fallon, host of NBC-TV’s popular “Tonight Show.” When the 40-year-old funnyman had trouble opening a tube of scar tissue repair gel with his hands, he decided to try using his teeth.

What happened next wasn’t funny: Attempting to remove the cap, Fallon chipped his front tooth, adding another medical problem to the serious finger injury he suffered a few weeks before (the same wound he was trying to take care of with the gel). If there’s a moral to this story, it might be this: Use the right tool for the job… and that tool isn’t your teeth!

Yet Fallon is hardly alone in his dilemma. According to the American Association of Endodontists, chipped teeth account for the majority of dental injuries. Fortunately, modern dentistry offers a number of great ways to restore damaged teeth.

If the chip is relatively small, it’s often possible to fix it with cosmetic bonding. In this procedure, tough, natural-looking resin is used to fill in the part of the tooth that has been lost. Built up layer by layer, the composite resin is cured with a special light until it’s hard, shiny… and difficult to tell from your natural teeth. Best of all, cosmetic bonding can often be done in one office visit, with little or no discomfort. It can last for up to ten years, so it’s great for kids who may be getting more permanent repairs later.

For larger chips or cracks, veneers or crowns may be suggested. Veneers are wafer-thin porcelain coverings that go over the entire front surface of one or more teeth. They can be used to repair minor to moderate defects, such as chips, discolorations, or spacing irregularities. They can also give you the “Hollywood white” smile you’ve seen on many celebrities.

Veneers are generally custom-made in a lab, and require more than one office visit. Because a small amount of tooth structure must be removed in order to put them in place, veneers are considered an irreversible treatment. But durable and long-lasting veneers are the restorations of choice for many people.

Crowns (also called caps) are used when even more of the tooth structure is missing. They can replace the entire visible part of the tooth, as long as the tooth’s roots remain viable. Crowns, like veneers, are custom-fabricated to match your teeth in size, shape and color; they are generally made in a dental lab and require more than one office visit. However, teeth restored with crowns function well, look natural, and can last for many years.

So what happened to Jimmy Fallon? We aren’t sure which restoration he received… but we do know that he was back on TV the same night, flashing a big smile.

If you would like more information about tooth restorations, please contact us or schedule a consultation. You can learn more in the Dear Doctor magazine articles “Porcelain Crowns & Veneers” and “Artistic Repair Of Front Teeth With Composite Resin.”